Page 1 of 1

Running MakeHuman from source

PostPosted: Sun Aug 30, 2015 9:01 am
by joepal
If you are reading this forum, you will most likely benefit from running MakeHuman from source rather than downloading a "build".

The steps for doing so are summarized here: http://www.makehumancommunity.org/wiki/ ... e_clone%3F

The API documentation is currently available at http://www.makehumancommunity.org/api

Re: Running MakeHuman from source

PostPosted: Sun Dec 16, 2018 7:20 pm
by make3
hello,

Do you think its possible to put all the Python stuff into the same folder ?

Re: Running MakeHuman from source

PostPosted: Fri May 10, 2019 10:30 am
by wolgade
As I was tricked by this thread, not realizing that Joel's initial posting is rather old:

If you're looking for the source code of MH 1.2, you'll go to https://github.com/makehumancommunity/makehuman. This page also contains instructions on how to get started.