Page 1 of 1
Export to CAD Formats
Posted:
Tue Jun 03, 2014 3:14 pm
by NXDude
This software would be very useful if it could export models to CAD formats such as Parasolid (.x_t) Step (.stp) IGES (.iges) Unigraphics (.prt)
Any idea when this may be supported?
Re: Export to CAD Formats
Posted:
Wed Jun 04, 2014 9:52 pm
by duststorm
I think most CAD software supports importing of at least one of the many formats that MakeHuman already exports, notably wavefront OBJ which is supported by most software. That should get you started for getting your mesh in CAD software.
Re: Export to CAD Formats
Posted:
Thu Jun 05, 2014 8:55 am
by NXDude
wavefront .obj is not supported in NX.