Page 1 of 1

Nose improvement suggestion

PostPosted: Wed Mar 26, 2014 6:14 pm
by LightBWK
Image

there is no slider to move the circled feature, stuck there on many models.
I hope a new target for that nose feature can be added. ;)
I want that part align able with nostril angle

Re: Nose improvement suggestion

PostPosted: Wed Mar 26, 2014 8:40 pm
by Manuel
Can you attach a sketch to illustrate before/after, in order to understand your request?

Re: Nose improvement suggestion

PostPosted: Wed Mar 26, 2014 9:57 pm
by LightBWK
Image

I hope this helps.
The suggestion is to have that middle part adjustable.

Re: Nose improvement suggestion

PostPosted: Wed Mar 26, 2014 10:06 pm
by Manuel
What about trying "Septumangle" and then vary the nose height?

Re: Nose improvement suggestion

PostPosted: Wed Mar 26, 2014 10:18 pm
by RobBaer
Manuel wrote:What about trying "Septunangle" and then vary the nose height?


Septumangle should read "Septum Angle" I think. I posted a low priority bug.

I was just looking for the same thing. Best combination for me was Septum Angle to the left and Nostril angle to right -- comes pretty close. Then, nose height to fine tune effect.

Re: Nose improvement suggestion

PostPosted: Wed Mar 26, 2014 10:46 pm
by LightBWK
Manuel wrote:What about trying "Septunangle" and then vary the nose height?


Septunangle with Nostril angle helped.
Nose height overly compressed the mesh above though.
Thanks for the help. :D