Page 1 of 1

HELP: small 3d prints

PostPosted: Wed Oct 20, 2021 11:42 am
by pierfra
Hi,
I love this software but I'm trying to print miniatures and how can you see in the imagines below, the trouble is the hole in the mouth where is the toungue. It's possible to fill this hole?
Thank you.
Image
Image

Re: HELP: small 3d prints

PostPosted: Wed Dec 01, 2021 2:19 pm
by raskull
If it was me, I'd probably open the model in Blender, then delete the inner mouth and tongue, then maybe face up at the back of the lips...?

Re: HELP: small 3d prints

PostPosted: Thu Dec 02, 2021 8:12 am
by pierfra
raskull wrote:If it was me, I'd probably open the model in Blender, then delete the inner mouth and tongue, then maybe face up at the back of the lips...?

Thanks, That's what I thought, but I'm inexperienced in blender and graphic sofwares. Do you know a simple tutorial about this procedure?
Thanks

Re: HELP: small 3d prints

PostPosted: Tue Apr 05, 2022 7:58 am
by silverrowan
meshmixer is made for things like this.

its a pain, but very doable -had to use it all the time with some artists to avoid resin traps.

Re: HELP: small 3d prints

PostPosted: Tue Apr 05, 2022 10:44 am
by joepal
One thing which might make things simpler for you might be using a low-poly proxy. You'd still have to close the mouth, so there's be some manual work. But with, for example, "proxy741", there is no internal mesh for the mouth.