New Target feature request

Tech support and suggestions forum. If you only have a basic question on how to get started, please use the "newbies" forum in the community section.

Moderator: joepal

New Target feature request

Postby Velonics » Sun Jan 05, 2020 2:34 pm

Hi, Can I request a control to deflate the internal mouth cavity - preferably to the limit of the inner lip surface? I am struggling with facet mesh editing to remove this 'open cavity' when preparing models for printing.
Many thanks, Chris
Velonics
 
Posts: 1
Joined: Thu Jan 02, 2020 3:56 pm

Re: New Target feature request

Postby tezzerii » Mon Mar 25, 2024 11:55 am

I've seen other posts on this problem, with answers involving complicated and fiddly editing to remove the mouth cavity.
I came up with a much simpler way to get rid of the mouth cavity !
In Blender, add a sphere. ( I go Add - Mesh - UV sphere)
Move the sphere into the mouth cavity and size it (S) to cover the mouth cavity.
Position the sphere just behind the lips so you can see that it fills in the mouth.
It doesn't matter if the back of the cavity isn't covered. And you don't have to join, weld, group or anything.
I've used this exporting stl to Prusaslicer, and it works fine.
Hope this is useful to anyone coming here searching on that problem ! =o)
tezzerii
 
Posts: 3
Joined: Wed Mar 20, 2024 5:58 pm


Return to Bugs, problems and feature requests

Who is online

Users browsing this forum: No registered users and 1 guest

cron