Page 1 of 1

Can't enable MH Community Plug-in in Blender

PostPosted: Fri May 10, 2019 2:57 am
by MTKnife
I just upgraded to Blender 3.79 last night, and downloaded the latest version of the MH Community Plug-in, and whenever I try to enable it in Blender, I get an error, specifically line 85 of the init file ("register register_class(cls)", which throws a ValueError with a message indicating that the class in question is already registered as a sub-class.

Re: Can't enable MH Community Plug-in in Blender

PostPosted: Fri May 10, 2019 11:04 am
by joepal
Can you write an issue on github and paste the stack trace there?

Re: Can't enable MH Community Plug-in in Blender

PostPosted: Sat May 11, 2019 1:15 am
by MTKnife
Will do when I get a chance--I just posted here to make sure I wasn't doing something stupid and obvious.

Re: Can't enable MH Community Plug-in in Blender

PostPosted: Sun May 12, 2019 12:55 am
by MTKnife
The next time I loaded it up it enabled just fine. I suspect the registration conflict came from trying to run two different versions of the plug-in during the same session, though I'm not positive I actually did that.