HELP: small 3d prints

Tech support and suggestions forum. If you only have a basic question on how to get started, please use the "newbies" forum in the community section.

Moderator: joepal

HELP: small 3d prints

Postby pierfra » Wed Oct 20, 2021 11:42 am

Hi,
I love this software but I'm trying to print miniatures and how can you see in the imagines below, the trouble is the hole in the mouth where is the toungue. It's possible to fill this hole?
Thank you.
Image
Image
pierfra
 
Posts: 1
Joined: Wed Oct 20, 2021 11:32 am

Re: HELP: small 3d prints

Postby raskull » Wed Dec 01, 2021 2:19 pm

If it was me, I'd probably open the model in Blender, then delete the inner mouth and tongue, then maybe face up at the back of the lips...?
raskull
 
Posts: 2
Joined: Wed Dec 01, 2021 1:57 pm


Return to Bugs, problems and feature requests

Who is online

Users browsing this forum: No registered users and 1 guest